Those cables will have to be rated for the heater which is being switched so most likely in. Domestic - Power cable for 2. Safe cable size for 3kw immersion heater. For some reason, the old immersion heater was connected to 1. The electrician that came to wire up the new system including the .
Advice needed - replacing immersion heater cable. Presuming a standard 3KW heater , I consider it poor practice to use a amp fused connection unit. UK which will handle up to 3kw , . Is normal power wire size ( ) OK, or do I need 4mm? It depends on the lengh of run, to use the 3kW heater. It has 2x 3kW immersion heaters.
I get a sparky in to swap the cables over.
No problem with the cable size and the 13amp fuse, just make sure that that the electric . Immersion heaters are usually rated at 3KW which, under normal circumstances. Cable Sizes for an Immersion Heater. Availabel Sizes of Immersion Heaters. The mains cable for an immersion heater is a two core and earth 2. A guide to selecting flexible cords and cables. To select the correct size of flex you must know the wattage of the appliance.
The Heater comes with an Ainstruction leaflet for the UK and has a power table on . If you use a fused spur you are still going to need to get the cable. The cable is warm to touch which worried me and is measuring 15. Did you also consider the size of the ripple?
If you go and buy a 3kw heater today it will have a 13amp plug on it. Hi An immersion heater must not be supplied by a ring final circuit. The proper butyl-rubber-insulated cable is rather large for most 13-amp plugs.
Obviously having two 3KW immersion heaters would heat up the . Special heat-resistant flex is also available for immersion heaters.
Check the table to see the size you need for different appliance ratings. At the moment my immersion heater has a cable running from a. A 3kW immersion draws around amps but should not be run from a amp socket.
No comments:
Post a Comment
Note: only a member of this blog may post a comment.